Netgear WGR614v9 - router is not responding

0 votes
asked Sep 7, 2013 by Puneet

problem : router's wifi status light is on but no wifi signal.

2. Can not connect to router via LAN cable also, on lan serup mode ,routerlogin.net page not available. On ipconfig, device ip :192.168.0.2 but default gateway ip is missing .

3. Ping to 192.168.0.1 is not working

4. Router stopped working after i tried setting it in repeater mode(as acess point to my root dlink router)

Reset to default factory mode is not working.

pls help. Thanks

3 Answers

0 votes
answered Sep 7, 2013 by machead3

Most of these must be accessed via Ethernet cable to set up - so set it up next to your computer. Factory reset should work, go over the directions again. Configuring two routers (or more) on a network is advanced networking. If possible (don't need wireless) a simple Ethernet Hub is easier to configure.

If this Answer is helpful please remember to return and mark it Accepted.

0 votes
answered Sep 17, 2013 by davidchase

You can try by resetting your router and re-configure it again. Please note that your all saved setting shall gone once you have done hard reset so i would suggest if your using ADSL then get your PPPoE account setting from your ISP first and then do this.

0 votes
answered Apr 3 by jasonmiller (180 points)

Router Login Netgear web interface is basically the control panel where all the basic and advanced configurations of wireless router are possible. Call us at 1-888-884-6940 to get instant technical assistance with your Netgear router.

 

Welcome to Questions and Answers, where you can ask questions and receive answers from other members of the community.
...