ultrafine mill process troubleshooting

0 votes
asked Mar 15, 2018 by birder2525 (4,440 points)

ultrafine mill in the use of the process there will always be some failure, it is understandable. But in the face of these failures, are you at your fingertips? Well, let  give you a summary of it.
The so-called What kind of disease to eat medicine, for the same ultrafine mill, different troubleshooting methods are not the same. The following has been classified as a problem, please read carefully one by one.
About ultrafine mill powder failure:
One problem: ultrafine mill powder or powder less output 
Causes: (1) lock powder is not adjusted well, the seal is not strict, resulting powder down suction. (2) large blade wear, material shovel can not afford.
Remedy: (1) Check and adjust the lock powder seal, leaks should be found blade. (2) replace the new blade.
Question 2: ultrafine mill finished powder too thick, or too thin 
Causes: (1) analysis of blade wear serious, can not afford the role of grading. (2) Fan air flow is not appropriate.
Remedy: (1) replace the blade length appropriate to turn off the fan to solve the air volume too thick. (2) Too small should increase the amount of imported air.

field1
gfhgff

Your answer

Your name to display (optional):
Privacy: Your email address will only be used for sending these notifications.
Anti-spam verification:
To avoid this verification in future, please log in or register.
Welcome to Questions and Answers, where you can ask questions and receive answers from other members of the community.
...