Just choose to high-quality mill equipment is not enough, we also need to carry out routine maintenance in order to truly achieve the high efficiency and high life of the equipment. The following describes the daily maintenance of grinder process matters needing attention.
1, the host center once every four refueling bearings, blower bearings refuel once a month.
2, the bearing chamber temperature shall not exceed 70 degrees.
3, roller device used for more than 500 hours to be replaced in time, replace the roller sleeve, the roller bearing and bearing room should be cleaned.
4, lubricating oil must be regularly added, pay attention to see when adding oil to moderate oil;
5, equipment operations to have some professionals, operators should understand the principle of milling machine performance, familiar with operating procedures;
6, it is recommended to develop a regular maintenance system to ensure the long-term operation of equipment;
7, also pay attention to grinder process boot, shutdown sequence and operation sequence, to be carried out in strict accordance with the instructions.
Combined with the above, as a fine powder experts, has always been committed to technological innovation and process improvement of milling equipment, enabling users to create greater economic efficiency with less cost! We not only provide customers with quality assurance products, more comprehensive caring service, installation and commissioning as well as the latter part of the maintenance, we will have the figure, is truly reassuring ultrafine powder manufacturers.